Thanks I will try shortening them and using a different GND point

Edit: That works Thanks.

Forgot to include the important picture... Thanks in advance

Ok someone has to help me out here. I have wired this thing every which way and still cant figure it out. Everything has gotten pretty beaten up since i did it so many times -- Can anyone point me in the right direction?

Yea basically that's what I did - after doing it 5 times.

Maybe its a dumb question, but how can i check the pins? On the left side of the cart there are those extra pads that i can check but for the side that actually used the sd card, I do not see how I would be able to check.

Ok someone has to help me out here. I have wired this thing every which way and still cant figure it out. Everything has gotten pretty beaten up since i did it so many times -- Can anyone point me in the right direction?

Phew perfect timing on picking up my project again.

1x for me - payment sent

I actually use a 15w iron with an extremely fine tip but that's because I was very new to this when I bought it years ago.

If you are new with soldering I would probably go a little lower until you get used to the process.

So after hours of wiring the buttons - I finally got to the screen (bought mine at micro center over the weekend- check their website). I got the SOIC-8 chip off with little issue but after constantly reworking the points because i couldnt get picture on the screen i lifted both the power and gnd pa...

I am having an identical issue..but not sure I am following on how to just reverse the composite output wires - Can you post a picture of how you corrected it?

Thanks in advance