Mintypi lite bezel causing screen glitches

[hwhitted05]

I found out today that the 3D printed bezel makes my mintypi screen glitches when it is attached. When I took the bezel off, all the games and menus worked perfectly fine, when I put it back on, it would work for a couple seconds, start glitching and becoming unresponsive, and then turn to a white screen. I’m using one of Helder’s presoldered boards for my Mintypi lite so I know it isn’t anything wrong with the internals. I took the bezel off and tested it multiple times and tested it multiple times with bezel on and got the same results.

[Bush Master]

Is the screen all the way in the 3d printed part. Some of the 3d printed parts where not big enough for the screen. I squeezed my screen in.
Another problem could be the ribbon cable. It could be bent or being pinched. A picture would be helpful.

[hwhitted05]

I checked many times so I’m pretty sure it was in the 3D printed part all the way. Here are the pictures with and without the bezel attached

[Bush Master]

The right looks like its in but on the left, the actual screen and not the board is hanging over a bit. It could be that. I know I had to wedge my screen in kind of like that.