Down button not programming on setup for RetroPie
Down button not programming on setup for RetroPie
I’ve put this in hardware as I think it might be a board fault. I’ve running a teensy I’ve wired it up in the order Wermy said on his video. I’ve programmed the teensy with wermys configuration. When running through the programming it will not register my down button. I’ve checked the voltages on the button pcb and it has no power on the down pad whereas the rest are registering 3v. I’ve got continuity between my pcb and teensy on that wire. Could it be a programming issue with teensy or a bad pcb? Thanks.
Re: Down button not programming on setup for RetroPie
Just checked resistance and I have 0.2-0.5 ohms on the down circuit on the pcb. I have multiple points I can check from and they are all reading this.
Re: Down button not programming on setup for RetroPie
It’s definitely a pcb failure put a wire from teensy ground wire to the down pin and it recognised the input instantly.
- YaYa
- Posts: 1719
- Joined: Mon Jun 26, 2017 12:42 pm
- Location: brittany - France
- Has thanked: 871 times
- Been thanked: 689 times
- Contact:
Re: Down button not programming on setup for RetroPie
You can reroute the defective track with a small wire and still use this board. Don’t be upset, this is not difficult to deal with !
Who is online
Users browsing this forum: No registered users and 1 guest