Hi guys,
Figured I'd be able to get some help and tips from everyone here on getting my workstation together. I've recently jumped into the world of electronics, so my tools are limited. What I have at the moment:
-A giant toolbox with all the general tools
-898D+ Soldering Station (Looking to upgrade to a Hakko FX-888D, pretty dissatisfied with the 898D+, but what was I supposed to expect it's generic)
-Screwdrivers (Big and Small Phillips and Flathead)
-Wire Stripper
-Helping Hands
-Multimeter
I do NOT have a hot glue gun or dremel.
What else would I need? Any other soldering station suggestions?
Need some help getting my workstation ready :)
- NarxElectronics
- Posts: 24
- Joined: Sat Aug 12, 2017 9:11 pm
- Has thanked: 17 times
- Been thanked: 23 times
Need some help getting my workstation ready :)
Last edited by NarxElectronics on Fri Aug 25, 2017 10:55 am, edited 1 time in total.
My first mintyPi build: viewtopic.php?f=32&t=3767
My second mintyPi build: http://www.sudomod.com/forum/viewtopic.php?f=32&t=4203
My second mintyPi build: http://www.sudomod.com/forum/viewtopic.php?f=32&t=4203
- moooarcuuuus
- Posts: 232
- Joined: Tue Jul 04, 2017 1:28 am
- Has thanked: 2 times
- Been thanked: 94 times
Re: Need some help getting my workstation ready :)
Crocodile clip with wires, resistors, capacitors, multimeter and a good power supply. Dont buy too much stuff now. You will get over the time all needed things. The local hardware store is your friend.
Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep... Game Over
Who is online
Users browsing this forum: No registered users and 1 guest