Filament question
-
- Posts: 171
- Joined: Sat Nov 04, 2017 3:04 pm
- Has thanked: 54 times
- Been thanked: 38 times
Filament question
I would assume that both ABS and PLA would work fine for the printing of parts for use in a MintyPi/GBZ/Similar projects, what is everyone using and is there any reason to use one type over the other for this sort of printing project.
- wermy
- Site Admin
- Posts: 1346
- Joined: Tue May 03, 2016 8:51 pm
- Has thanked: 620 times
- Been thanked: 1322 times
- Contact:
Re: Filament question
Depending on what kind of printer you have, PLA can be much easier to print than ABS (so for the mintyPi for example, it's easier to get a nice flat faceplate with PLA rather than ABS usually). I use ABS for parts that need screws threaded into them as it's a little tougher. But honestly, as far as the actual characteristics of the materials go you're probably fine using either one.
-
- Posts: 145
- Joined: Sat May 20, 2017 3:06 am
- Location: Amsterdam, The Netherlands
- Has thanked: 48 times
- Been thanked: 43 times
Re: Filament question
https://www.3dhubs.com/knowledge-base/p ... difference
- ABS and PLA are the most common desktop FDM printed materials and are typically similar in cost. ABS has superior mechanical properties but is harder to print with compared to PLA.
- PLA is ideal for 3D prints where aesthetics are important. Due to its lower printing temperature is easier to print with and therefore better suited for parts with fine details.
- ABS is best suited for applications where strength, ductility, machinability and thermal stability are required. ABS is more prone to warping.
-
- Posts: 23
- Joined: Sat Feb 09, 2019 5:07 pm
- Has thanked: 5 times
- Been thanked: 9 times
Re: Filament question
I’ve heard PETG has the benefits of both
YouTube https://www.youtube.com/channel/UCY60K9 ... TMiUan7UQ/
Instagram https://www.instagram.com/staticnebula26/
My First MintyPi v3 Build Log https://www.sudomod.com/forum/viewtopic.php?f=32&t=7669
Instagram https://www.instagram.com/staticnebula26/
My First MintyPi v3 Build Log https://www.sudomod.com/forum/viewtopic.php?f=32&t=7669
- DieselDummy
- Posts: 197
- Joined: Tue Oct 24, 2017 12:20 pm
- Location: Florida, USA
- Has thanked: 80 times
- Been thanked: 92 times
Re: Filament question
I prefer to print PETG over ABS, it doesn't smell as much and the warping/ bed adhesion seems better. PLA is the easiest to work with in my opinion, but doesn't seem to have the same strength and durability.
Links
"Battery Cover Buttons" install guide and support
My CSO build #1 - with "Battery Cover Buttons"
My CSO build #2 - the "sudoNod"
My MintyPi v3 build #1
"If you're bored, you're boring."
"Battery Cover Buttons" install guide and support
My CSO build #1 - with "Battery Cover Buttons"
My CSO build #2 - the "sudoNod"
My MintyPi v3 build #1
"If you're bored, you're boring."
Who is online
Users browsing this forum: No registered users and 1 guest