Nice. Thank you.
Search found 8 matches
- Mon Mar 18, 2019 10:29 am
- Forum: Show-off Corner (VMµ)
- Topic: Robochris’ Gem
- Replies: 5
- Views: 9778
- Sat Mar 16, 2019 7:16 pm
- Forum: Show-off Corner (VMµ)
- Topic: Robochris’ Gem
- Replies: 5
- Views: 9778
Re: Robochris’ Gem
Yes please. Always nice having options. Gotta love 3d printers. Wish a vmu shell stl existed.
- Tue Mar 12, 2019 12:22 am
- Forum: Show-off Corner (VMµ)
- Topic: My GEM VMU
- Replies: 8
- Views: 12054
Re: My GEM VMU
Great clean build! Silly question but I couldn't figure out where the test pads for about a dozen points were. I have seen the diagram but for example, for LCD DC, it's point J but uh where is the partner pad? I don't see it anywhere on the PCB. Same with the other LCD, also BATT MON, TXD, RXD, etc...
- Tue Mar 12, 2019 12:17 am
- Forum: Show-off Corner (VMµ)
- Topic: My GEM VMU
- Replies: 8
- Views: 12054
Re: My GEM VMU
Nope. I removed nothing.
- Sun Mar 10, 2019 3:57 pm
- Forum: Support (VMµ)
- Topic: GEM Blank screen
- Replies: 4
- Views: 4546
Re: GEM Blank screen
Do you have a multimeter you can use to check continuity with? I thought all my solder joints we're good but I couldn't get the screen to save my life. Turns out I had a bad screen reset joint. Kite has the pinout on the FAQ, double check to make sure the pins and the breakout points match up. Also...
- Sun Mar 10, 2019 3:55 pm
- Forum: Show-off Corner (VMµ)
- Topic: My GEM VMU
- Replies: 8
- Views: 12054
My GEM VMU
Took awhile to finish due to lack of time but the hardware part is done. I completed assembly of my GEM and I like the board. Board tinned. 20190302_084328.jpg Case prepped. The plastic was softer than I expected. Flush cutters did the whole job. I did end up needing to trim the side walls on the ba...
- Sat Mar 02, 2019 7:12 pm
- Forum: Support (VMµ)
- Topic: GEM Blank screen
- Replies: 4
- Views: 4546
Re: GEM Blank screen
Thanks for the information. I will grab a multi meter on Monday and check everything.
- Sat Mar 02, 2019 11:10 am
- Forum: Support (VMµ)
- Topic: GEM Blank screen
- Replies: 4
- Views: 4546
GEM Blank screen
Well I started working on my GEM kit today and seem to be stuck getting the screen going. I went back over all the pins and they seem to go all the way through. I changed the file on the sd to run debug and the green light on the pi flashes like it is reading. Backlight comes on for the lcd. Is thei...