Search found 3 matches

by Tophool
Fri Jun 07, 2019 1:58 pm
Forum: Support (mintyPi)
Topic: Shoulder Buttons Fell Out...
Replies: 9
Views: 883

Re: Shoulder Buttons Fell Out...

I've had the same issue...I'm wondering if you were to connect the two buttons into a single silicone button strip, it would hold them in better. Same with the start/select buttons. They keep sticking, and when I went to try and tease them up again, they get pulled out of the socket. It's a pain in ...
by Tophool
Thu Jun 06, 2019 2:38 pm
Forum: Support (mintyPi)
Topic: Sticky Start/Select Buttons
Replies: 0
Views: 324

Sticky Start/Select Buttons

I've noticed after playing a bit with the assembled MintyPi v3, that the start and select buttons tend to stick inward rather than pop out naturally like the rest of the buttons. Sometimes it's so bad that they are stuck in a pressed position and the shortcut codes are activated accidentally (such a...
by Tophool
Wed Jun 05, 2019 6:12 pm
Forum: General Chat (mintyPi)
Topic: Hinge MOD
Replies: 0
Views: 638

Hinge MOD

I got sick of the hinge constantly coming off the hinge support, so I modded it a bit to be held in place by one of the small screws provided in the kit and a 3D printed cap. I had to file a small amount off the screen bezel to accomodate the sliver of screwhead protruding from it, but that was easi...