I was in the first batch for v3 pcbs, had to fix my screen and sent my powerboard over to Helder to replace that one part that needed replacing on the powerboard

Nope, I am not using usb for power, Im on the powerboard, Gambino mentioned a dualfet, he was using different ones or something? Sorry Im not well versed in all this yet

Ok I just got back from vacation, so should I be planning on rereplacing that part?

But wasn't your board the one you kind of messed up desoldering the wrong chip? It's likely something that got damaged with the process of desoldering. The board did look horrible when you did that so not sure what got damaged in the process. I sent my board to you for desoldering and replacing the...

Just to make sure: You are using the power board and off battery. When triggering the halls sensor, it goes through the process but does not cut the power? And the power button turns it on but won't turn it off when held? This is all correct, I had the whole thing put together and yep, just wont fi...

I'm completely stumped here, should I try and reflow anything? or try replacing the pi?

And I finally got another SD card, still doing the same thing

Yes, Im only using the mintypi as its built, so Im on the battery and powerboard I got from you guys, and the 3.28 was just what I was getting steady with the power on, I can go back and check as the shutdown happens

With power on I'm getting 3.28V and at the screen I get stuck at I'm getting 0.2mV, and the power button will not force it to shut off

I've been having this problem with a fresh image, just tried again after specifically making sure I went through and disabled ftp and the same thing did happen. I'll pick up another card when I can, but I just flashed the old v3 image and its doing the same thing