I put a fresh Image on the stick and now it’s working... thank you.
Back to the temperature, is it normal that without Fan the temperature is always around 60 Celsius ?
Search found 7 matches
- Thu Jul 04, 2019 4:50 pm
- Forum: Support for Kite's Products
- Topic: Freeze after a couple of seconds
- Replies: 9
- Views: 5063
- Wed Jul 03, 2019 5:11 pm
- Forum: Support for Kite's Products
- Topic: Freeze after a couple of seconds
- Replies: 9
- Views: 5063
Re: Freeze after a couple of seconds
Ok ... it’s doing the same, but I think it’s not getting this hot outside of the shell, maybe it was the same before. But I figured out that it’s not freezing befor I try to setup the buttons. Emulation Station setup says „Hold a button to start“ ... in this State it won’t freeze, I can reply this (...
- Tue Jul 02, 2019 4:03 pm
- Forum: Support for Kite's Products
- Topic: Freeze after a couple of seconds
- Replies: 9
- Views: 5063
Re: Freeze after a couple of seconds
So... it’s getting warm to hot after about 2-3 Minutes. I can still touch the heatsink, but in my opinion it’s very warm for doing nothing than freeze.
I didn’t solder the Fan for now, is it because of that, I think no, or !?
I didn’t solder the Fan for now, is it because of that, I think no, or !?
- Tue Jul 02, 2019 4:10 am
- Forum: Support for Kite's Products
- Topic: Freeze after a couple of seconds
- Replies: 9
- Views: 5063
Re: Freeze after a couple of seconds
Hi Kite, you remember me … its the board (CS CM3)you had in your hands a couple of days/week ago (Bastian from Germany). You Setup everything (you Changed the Pi3 CM3, updated the Ardunio) . The only Change I made in the Settings, was setting the Resolution to 640 x 480 and solder the Bridge on the ...
- Sat Jun 29, 2019 11:51 pm
- Forum: Design Sharing (3d Printing)
- Topic: 640x480 LCD bracket with PSP joystick
- Replies: 11
- Views: 17868
Re: 640x480 LCD bracket with PSP joystick
I m located in Germany, shipping fees are no problem. As long as it’s very good. Because I already have one and it’s crappy print. Better print to if possible.
- Sat Jun 29, 2019 4:45 pm
- Forum: Design Sharing (3d Printing)
- Topic: 640x480 LCD bracket with PSP joystick
- Replies: 11
- Views: 17868
Re: 640x480 LCD bracket with PSP joystick
Is there someone who can print me this Adapter in good condition or show me a website where it can be done.
Thanks in advance
PM please
Thanks in advance
PM please
- Sat Jun 29, 2019 2:09 am
- Forum: Support for Kite's Products
- Topic: Freeze after a couple of seconds
- Replies: 9
- Views: 5063
Freeze after a couple of seconds
Hi Guys, I am a bit new to this, but I finished my project know completely. The problem is, when I switch my Boy on, it boots up normally, but after a while it freezes (seconds, maybe 20-30). It happens normally when I try to setup the button configuration, or maybe in a another state. As faster I a...