OK, i have SSH enabled, and i go to my Mac and i try to connect via ssh pi@raspberrypi.local and i get nothing. Any help here? I connect to my Raspberry Pi 4 all the time via VNC, but i cannot connect here. Any tips?

Well, i was using my 640x screen, but i swapped it out to the stock 320 screen (after undoing the config.txt steps to enable it) and it boots, so i may have a bad screen.

My build has stopped booting. When i plug in the board, it gets power and the LEDs all light up, but nothing happens on the screen. I enabled wifi via adding a wpa_supplicant.conf file to the boot section of the sd card. The board never connects to my wifi, any way to confirm this is the issue. Than...

Thanks! So i discard the third wire on the fan?

OK, where do i hook up the fan? I see TWO tiny (TINY) fan pads at the very top of the board: however there are THREE wires coming off the fan? What do i do?

Thanks so very much!

OK this has just happened to me ... how can i replace this clamp?

My board finally arrived. What size screws do i need for all this?

OH, man ... with all this COVID crap i missed ANOTHER preorder. I have all the parts to build this except for the circuit sword. Fingers crossed for another pre-order.