FINISHED - more pictures and build log in the topic start.

BadBert wrote:How are the 3d printed parts holding up

The button wells are perfect. The screenpost is in place but I haven't closed the case yet with screws. When I've solved the audio issue I will close up the case.

alien0matic wrote:Try putting the audio cables somewhere else. If that doesn't work try shielding it.

What can I use to shield the wires? I can't reroute them...

I've almost finished my GB Zero build but have a strange issue. Before I assemble the GB I powered it up for a final test. But now the Pi's act led is flickering. At the same time the speaker is making noise. Is there somebody who can point me to the right direction? Here's a video where I power on ...

I've almost finished my GB Zero build but have a strange issue. Before I assemble the GB I powered it up for a final test. But now the Pi's act led is flickering. At the same time the speaker is making noise. Is there somebody who can point me to the right direction? Here's a video where I power on ...

@Camble, I will go shopping tomorrow to get a 100k resistor just to be sure

I've one more question. I ordered the jfet and resistors but the send the wrong resistor value. I have some 10k resistors, will that work or must it be 100k? I also have one 180k on the DMG board which I can reuse.

I was planning to work on the GameBoy this weekend so I cant reorder and wait...

Hi all, I want to implement this by using the original DMG-01 switch but I'm not sure how to wire the components. Can someone point me in the right direction?

All the major parts are delivered. Yesterday I started with the screen assembly. See the topic start for pics.

Just tested the screen with the PowerBoost as power source and it works!

Now I have all the needed parts I can finally start with the assembly.