I have the same Display, you need to connect your 5V to Pin 2 of the A5269 Voltage Regulator. Pin Number 3 ist the 3,3V output of the Voltage Regulator unfortunately that means you killed the whole board Here is a picture how i connected the Voltage Regulator: http://imgur.com/a/Z4KoE I'll fiddle a...

I soldered the wire to pin 3. I'm pretty sure I killed it. I'll try a few more things tomorrow

fcib wrote:
Use a jumper or solder the red wire to pin 3 of the A5269 chip.

That is connected to the output, so it should work. Don't blame me if you burn your house down though.

That's what I was guessing after reading the spec sheet. It will be fun to solder the tiny pin :S

They're really hard to read but I manged to snap some photos
The one near the large capacitor is A5269 BM56AC .
The other is MAIKE 25040BSSIG 1446

Did anyone ever figure out how to modify this board for 5 volts?

The flickering is driving me nuts.

I can confirm this screen is not 640x480

Ordered 1. Thanks mate

I end up purchased one of the screens "640x480" screens from aliexpress as well. I'm hoping that you're going to have good news while I wait a few weeks for it to arrive.

The seller has assured me a few times that the screen is 640x480, I still don't believe him.