Thanks rodocop. With mintyPi_v4 screen quality is not very good, when scrolling is little blur and vertical sync is poor. I want to try if this version improves the quality of my screen... I know there are better options to use mi screen (SPI TFT LCD ILI9341 3.2"), like: https://sudomod.com/forum/vi...

Hello.

I burnt mintyPi_v4 and works OK with a 3.2" SPI TFT LCD but I want to try with the last version, Mintypi v3, but screen doesnt works properly, screen flickers and show strange and deformed figures. Have I to change something in config.txt to work?

Thanks.

Finally I could fix the problem. As I suspected, SPI screen doesn't works with a clean install of retropie until you instal drivers I don't know why didn't you warning, although I asked you several times about this. Sincerely, your attitude was very arrogant.

Regards.

But something is very strange, I only have to burn SD and put it into RP0. If I burn retropie-4.4-rpi1_zero.img in a SD, then the first time I insert SD into de RP0, must I see image in the screen or have I to configure something in config.txt before insert SD?. EDIT1: I am going to burn the etropie...

I joined screen to raspberry with this:

https://oshpark.com/shared_projects/zUNmnlLF

I suppose solders are OK because screen works with mintypi. When I can I will take some photos.

Regards.

If I burn a retropie-4.4-rpi1_zero.img in a SD but when I swich on my Pi0 with the SD I get a white screen...
My screen is a 3.2" SPI TFT LCD.

I think in this time I hadn't permissions and commands doesn't work.
Is it possible?What must i do?
I am going to try again.

Sorry but I dont know anything about linux...

I had burnt SD with Mintypi v4, then insert SD in raspberry pi zero and follow your steps: via Raspi Config (in the Retropie menu) disable SPI enable Overscan reboot I've done this via SSH this is meant to be done at the end, but I found I couldnt even get to this point (so I've done it first) Code:...

I burnt mintypi v4 and works OK with a 3.2" SPI TFT LCD but I wanted to try to improve quality screen so I followed all that steps. The result is a screen full of deformed lines
Have I to burn the image of mintypi again?

First Thanks for all.

I have bought a 3.2" SPI TFT LCD, I burnt my SD with "mintyPi_v4", Do I need to configure some parameter to improve the quality of screen or "minty pi v4" is ready for get the best quality of this screen ?

Thanks again.