Have you verified that all connections are valid where they are supposed to go via volt meter? what do you mean by valid where they are supposed to go? I have made sure that each wire connecting to the PI (all the PP spots) are connected to the SD card card reader pads and show continuity and verif...

Hey so I really want to add the cartridge reader into my build but, after three different SD card readers and no responses to previous post I'm feeling like its a lost cause.. From previous threads I have read on the Kitsch Bent Cartridge Imaged below you can use any pads.. I'm starting to think thi...

@helder when do the pre-orders end today?

and will this version be your last or will you most likely update it again? ( just finished regular GameBoy-0 looking to make a new one. cleaner, more room and bigger battery)

Posting to get to top of thread** any help is appreciated folks!

Hey so I know the cartridge reader is not a necessity but, I would love to have it in my build. When I insert both Mini SD( I have two just in case one wasn't working like @wermy mentioned in video 5) into my cartridge reader my PI wont even turn on so clearly its not getting a read from the SD card...

I normally wouldn't recommend re-using capacitors, but there are quite a few tiny little ceramic capacitors on the GameBoy. I just used one of those. Okay so take a look and find one.. So I take it the 33nf would not work then bummer.. This one I found pretty cheap and relatively close to my house....

@Camble I probably cant use the 33nf capacitors in the SD card reader though correct? @wermy says he uses a 1.0 uf and I did the conversion the capacitors I have are only .033uf (33nf).. I have no idea what this in fact means but it seems that its much less than what he is using. Would you suggest p...

So I purchased these capacitors. https://www.amazon.com/gp/product/B005XIRGJ2/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1 My question is do these work for the 33nf that we are required to use and I know it says you can use 2x 10nf if you dont use 33nf but can I use 2 x 33nf instead of a 10nf? /Siden...

Yes the L & R you connect to the tactile switch, each switch has a GND and a labeled Solder Hole on the corners of the board you solder to the tactile switch. Then once it's connected you connect the center Solder hole to the Teensy. EDIT: I just re-read your post @Thatbraziliann and you simply con...

Follow Wermy's video guides but skip the board cutting and follow the teensy part. Each hole on the board I labeled so solder the corresponding wire from the teensy to the board, pretty easy to do. Hey @helder I have your original 1st batch board and @wermy on his videos connect L/R tactile ground ...