Ha! and one thing too, my sd card works very well on my first game boy ...
Maybe the sd card reader?

Good evening to all.

hello KITE, hello everyone, I have just finished my second gameboy zero and everything worked perfectly until the screen remains blank during certain starts, then each time I start :-( Now the screen does not display anything but is on (backlight on). I have re checked, in particular the connector o...

Ok thanks you.
I will use them in my next GB zéro !

Hi kite,

While waiting to receive my new vircuit sword, i was wondering if i could use a 3.8v battery with it instead of a 3.7v battery ?
(that' s because i have a few of these battery)

Thank' s you !

hi kite, I' ve just seen your last reply kite and after trying 4 or 5 time to reconnect the CM3, the led near the sd card reader is still off. Is this the led which is just near the CI between the SD card reader et the CM3 ? ok yes it is ! i' ve seen the USBHUB letters on the circuit board; so this ...

ha and i(ve forgotten, there is a red LED under the CM3 which is on too
on the upper side the red an blue LEDS are on, the yellow randomly flashes.
Near the fan (upper left) a green LED randomly flashes too.

hi kite,
thank you for taking a look at my problem.
here is a picture of the inside when the boot sequence fail:
sorry, i don' t know why my pictures are automatically -90° rotated.

hello all of you, hello kite, It seems that my first serious problem with the KITE' S CIRCUIT SWORD have just arrived. Here is the problem in image: So, since a few days it is impossible to go further than the screen you can see in attachement. All buttons are disable except the power switch which i...

hi,

thank you for the explanation ! sure that i wanted black and i wrote white and vice et versa in the config.txt.
Ok now i' ll try to re edit it with correct arguments... and also try to speak english a little better

You understand me and it is already good !

Have a good day.

hi kite, thank' s for looking at my small problem. Yes i have edit the config.txt file because my first time plug with hdmi to TV was' not a success. My config.txt: # NOTICE: This file is managed by the Circuit Sword software and is used to # facilitate HDMI/DPI switching. Do not edit any lines that...