Yes, I used that image file. I was able to access the /boot/config.txt and these were my audio settings: # 2 channel audio dtoverlay=pwm-2chan,pin=18,func=2,pin2=13,func2=4 # 1 channel audio dtoverlay=pwm,pin=18,func=2 I did some sound tests and I still didn't have any audio. I tried deleting "1 cha...

At the right side of the headphone jack on the v2.0 board you can power your external USB port with the 5v and GND pins. Green and white wires goes to the data pins on the Pi. Thanks so much, Tinkerboy! I was hooking the USB up last night and I completely reversed the pin positioning on the externa...

Thanks so much, Tinkerboy! I just tried it out and my screen works perfectly. I have another question. I'm trying to hook up my external USB port, and I'm unsure of where to attach iti. I found a tutorial on how to setup a micro-USB on your website but I wasn't sure if this would be the same wiring....

I couldn't find much info related to the Tinkerboy V2.0 PCBs so I figured I'd ask some general questions! So far my build is going great, but I'm running into some trouble in terms of two items "fighting" over the same soldering spots. In this build, it looks like I should be wiring my PCB power sup...

So this is my first build and I'm going the BW screen route and I found my screen is variant #7. I went through and removed the IC and attached a wire to the correct spots. I downloaded Retropie and etched it onto a formated 16 gb SD card and inserted it into my Pi Zero. I wanted to go through and d...