It is 0.5E1 Edition. The USB Cable is wired to here - Capture.JPG At the other end I use this Capture 2.JPG Then it is attached to the pi's USB port, i.e. easy removal of the pi. The power to the pi is done via 2 jst connectors the female connector is connected to the Pi 3 ext board, the male connec...

Please check the ribbon cable closely. There might be a tiny tear on the ribbon cable. I had same problem with one of my builds, turned out there is a tiny tear on the ribbon cable near to the screen. The screen just got power and due to the tear would not get the signal. Got the replacement screen ...

First and foremost it opens up the option to upgrade to Pi 3 if needed. Another is it is much easier to solder.

Nope...I am not opening it up just to take the pics of the inside

It is the same as any Kite's based build, no differences here.

Yes it is another build with Kite's SAIO but this time with Kite's Pi 3 EXT board and Pi Zero and not Pi 3. Standard build same as everyone else's. Features - Stereo Glass Screen protector All the buttons: A B X Y L1 R1 L2 R2 20171127_181040.jpg 20171127_181120.jpg 20171127_222051.jpg 20171127_18114...

Seems there are two versions of this 1up board. from the video OP shows @6.02 1Up connected the headphones jack to HDMI board. From another video on youtube this guy connected the sound to the pi3 headphones jack - https://www.youtube.com/watch?v=Ap47fu1u6vI. Just for sanity check OP can go to retro...

I am sure more people will be using the 3.5 inch HDMI screen and it is a problem for most people that do not have the right tools. It is just a case of grinding down both sides of the front case (just a groove that allows the screen to "slide" in. Almost the same as with 640*480 screen that Kite's b...

All the "new" screen are the same size, it listed @ aliexpress at 8.6 cm. It is difficult to get a hlod of the "old" screen. The PCB is the same (from what I can see. You have to grind out the sides of the case and also cut the plastic near the ribbon cable for the screen to fit in to the case which...

@Derock89 -I have a few spare Banggood Power boost, PM me and I'll send you two... But why change the power boost when the amp is the problem? (I know that I said change the power boost to the one that capable of outputing more ampere). What is the amp that 1UP uses in his build? Is it stereo or mono?

It would take around 5 to 6 hours to build with Kite's SAIO, if you are confidence and solder in one go.