Search found 9 matches

by Boohyaw
Sat Mar 02, 2019 10:18 am
Forum: Support (mintyPi)
Topic: Prebuilt MintyPi: Broken. :(
Replies: 5
Views: 4665

Re: Prebuilt MintyPi: Broken. :(

The only thing that's wired to the vcc is the usb positive on the sound card.
by Boohyaw
Thu Feb 28, 2019 7:17 pm
Forum: Support (mintyPi)
Topic: sound card issues, Button issues
Replies: 7
Views: 3787

Re: sound card issues, Button issues

Are you using the resistor settings for continuity? You should be using diode mode. I'm not sure what either one of the those are. I am setting my multimeter to the ohms setting at 200. It's a pretty cheap one from wal-mart. So I got my new tip in today went thru and redone all the GPIO pins. Power...
by Boohyaw
Wed Feb 27, 2019 7:50 pm
Forum: Support (mintyPi)
Topic: sound card issues, Button issues
Replies: 7
Views: 3787

Re: sound card issues, Button issues

I am not showing continuity between the ground and the GPIO. None of the GPIO pins are grounded. I was also able to verify the left, right, down, and B buttons work. Up and A are the ones that don't seem to work. The continuity between the pads and GPIO pins are all at about 3 ohms. Is that still co...
by Boohyaw
Wed Feb 27, 2019 7:33 am
Forum: Support (mintyPi)
Topic: sound card issues, Button issues
Replies: 7
Views: 3787

Re: sound card issues, Button issues

Helder wrote:
Tue Feb 26, 2019 11:26 pm
Might have a bad GND point, there is another one below the A button GPIO. It could also be weak solder joints since you don't have the proper tip.

Check to see if the button GPIO are touching GND by doing a continuity test.
Ok I'll check and see what I come up with.
by Boohyaw
Tue Feb 26, 2019 8:54 pm
Forum: Support (mintyPi)
Topic: sound card issues, Button issues
Replies: 7
Views: 3787

sound card issues, Button issues

I have a short between my data positive and my data negative wires. I am currently waiting on a new soldering tip to come in. I am wondering if it has any effect on some of my buttons not working. From what I can remember all of the buttons were working fine before I finished soldering everything. I...
by Boohyaw
Mon Oct 01, 2018 3:07 pm
Forum: Support (mintyPi)
Topic: Battery charger
Replies: 6
Views: 4791

Re: Battery charger

Appreciate the help!
by Boohyaw
Sun Sep 30, 2018 9:24 pm
Forum: Support (mintyPi)
Topic: Battery charger
Replies: 6
Views: 4791

Battery charger

I wasn’t paying attention and bought this charger, https://www.amazon.com/McIgIcM-Battery-Charging-Charger-lithium/dp/B06XXYTRGK/ref=mp_s_a_1_11?ie=UTF8&qid=1538364067&sr=8-11&pi=AC_SX236_SY340_QL65&keywords=adafruit+micro-lipo+charger&dpPl=1&dpID=5129lIQmO3L&ref=plSrch Will it work for my build or ...