I have GPIO feeding the filter. Then a single connection coming out of the filter off of the 10uf capacitor which goes to L-IN on the Pot. L-Out is connected to Audio+ on the amp. And GND on the Pot is connected to Audio- on the amp. Thats basically it. Oh, and my pot sucks. I'm desoldering another...

So I built my filter today, but not sure if it is hooked up right. I just thought I would post it here for some feedback. I have not hooked it up the pi zero yet because I am not sure which wires go where. I have the two wires from the amp (from the guide) ready to go, but not sure which ground to u...

So I built my filter today, but not sure if it is hooked up right. I just thought I would post it here for some feedback. I have not hooked it up the pi zero yet because I am not sure which wires go where. I have the two wires from the amp (from the guide) ready to go, but not sure which ground to u...

modded the cartridge reader...was actually a lot easier than I expected. I had to expose some of the traces on the game cartridge so that all of my pins were sequential. It was a pain soldering wires onto the pins because they were in order, so I recommend spreading out the pin selections a bit. I h...

If you would like to take a crack at it here is my guide. Hopefully it helps! If you still have issues let us know! http://www.sudomod.com/forum/viewtopic.php?f=22&t=480 I made a simplified schematic for anyone who might not understand the original schematic. @1461748123 did a great job with his, y...

I saw this online...thought I would share.
https://www.reddit.com/r/gaming/comment ... boy_color/

I am at the same point...I was waiting for the guide, but I have been getting ancy and want to jump ahead. All I have left to do is the cartridge reader and audio. There is a forum topic on low-pass filter for audio out that I have been following that has a picture of what the audio filter should lo...

My updated GBZ...successfully got all the ports wired up using the diagrams and pics of wermy's build. All of my buttons work now (had to resolder some gnd connections on the controller board). There is a little light coming in on the sides of the screen that I will need to address at some point too...

my workspace is kinda small but works!

Here is my updated progress...I kinda stared before Wermy's guide part 4 so I got ahead using the wiring diagrams on the forum [spoiler="power switch mounted"] http://i.imgur.com/LL7W1Bf.jpg [/spoiler] [spoiler="2500 mAh battery placement"] http://i.imgur.com/OK9klQt.jpg [/spoiler] [spoiler="micro u...