Honestly, I am not even sure where to begin troubleshooting my psp 1000 joystick. I used the above schematic and had 0 input from the joystick. The system didn't even register it was there. Then I looked at another users finished product thread. Looked at how they soldered the cables and then re-did...

I have version 0.6C1 20170716. And I am a bit confused on the 3.3V jumper and 5V jumper. I was originally using the wiki and it looked like both were supposed to be soldered when using a Pi3. But then I learned about the PDF for assembling this and it states that I should only use one or the other....

There is 4 pins to solder and there is an easy to find layout for them. The layout says: VCC- UP/DOWN - GND - LEFT/RIGHT The one on the wiki says to do White/Black/Red/Green for that order. But on Kites SAIO board the input list the cords as GND/Joy Y/3.3v/Joy X. Using the 4 wire JST that'd be Red/G...

New case arrived. Thanks again man. Hope you had a good holiday season.

Really nicely done cases though!

Looks really nice so far.

Sorry if it's been asked before, do you have a link to where I can get a battery like that? I've tried looking on eBay and Amazon but I must not be using the correct keywords to find it.

I put one in the gba folder and one in the bios folder in the rom area. Not sure which one it uses but it seems to help.

VolumeControl::init() - Failed to find mixer elements! That is the error I am receiving on top of not having any volume from games or in menus. I found this thread discussing the issue about retropie = https://github.com/Aloshi/EmulationStation/issues/433 And it is a little confusing but I think I g...

The one I initially used want vhb tape at all. It was super thin tape meant for the glass covert if a gbz. It stuck more than when I used vhb tape. But I bought the one recommended by wermy.