Help With Game Gear Pi Mod

Got an idea for a project? Found a cool project you want to share? Post it here!
Post Reply
Posts: 1
Joined: Mon Aug 31, 2020 8:48 am

Help With Game Gear Pi Mod

Post by Big_F_Dawg » Thu Sep 03, 2020 6:37 pm

Hello All,

I'm ordering parts to run a Raspberry Pi in a Game Gear. I would like to use the GG's power board if possible. Several folks have managed to run a Pi 3 with good results including

The GG power board ( can supply 5V, but I am confused as to what the amps will be. I would like to run a Pi 4, which requires 3A ( ... fications/). I will also be using a 3.5" LCD via HDMI and some of these can consume close to 500mA.

Will the GG power board be enough for my Pi & screen? What do I look for when reading the specs sheets in order to calculate amps? Do I need some sort of booster/regulator? My electrical knowledge is sorely lacking so any input is appreciated.

Also, I'm planning to add a few controls. Final count will be 11, or 13 if I try to set up a joystick. The Teensy 2.0 would be perfect, but it only has 12 analog inputs ( Should I just upgrade to the 3.2 or look elsewhere?

Thanks a bunch. I will take photos and post a write up if all goes well.

User avatar
Posts: 532
Joined: Mon Dec 24, 2018 11:46 am
Location: Portland, OR
Has thanked: 220 times
Been thanked: 193 times

Re: Help With Game Gear Pi Mod

Post by infinitLoop » Wed Sep 09, 2020 1:11 pm

the GG board is 9v i think, so i believe that you will need to step it down to 5v to work with the pi. not sure if there'll be enough current to run everything, but it's possible

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest