First Fix/Project

Got an idea for a project? Found a cool project you want to share? Post it here!
Post Reply
BlooZio
Posts: 2
Joined: Tue Aug 03, 2021 1:11 pm
Has thanked: 1 time
Been thanked: 1 time

First Fix/Project

Post by BlooZio » Tue Aug 03, 2021 1:44 pm

Untitled_Artwork.png
Untitled_Artwork.png (9.91 MiB) Viewed 3569 times
Hello, Im completely new here, and completely new to soldering. Im trying to learn by fixing broken electronics, and my first victim is a pair of broken bone conduction headphones. One of the mics broke off snapping two wires away from the board that was set inside the bulb. So my question is, can I just use existing solder joints to reset the wires of the broken mic onto the board? Would this even work as a fix?

Dividion
Posts: 95
Joined: Fri Mar 30, 2018 5:42 am
Has thanked: 58 times
Been thanked: 69 times

Re: First Fix/Project

Post by Dividion » Fri Aug 06, 2021 12:04 am

If it was just the wires that snapped and the pads weren't ripped off the PCB, that should work fine.
Check out my store for GBZ boards and accessories: http://pocketadventures.com

BlooZio
Posts: 2
Joined: Tue Aug 03, 2021 1:11 pm
Has thanked: 1 time
Been thanked: 1 time

Re: First Fix/Project

Post by BlooZio » Tue Aug 10, 2021 10:22 am

Dividion wrote:
Fri Aug 06, 2021 12:04 am
If it was just the wires that snapped and the pads weren't ripped off the PCB, that should work fine.
And it did! Fix was a success! I’m so happy and excited! These were a gift from a good friend of mine and I’m so happy to have them working again! Thanks for your input. :)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest