Getting a wonderswan in a couple of weeks! I have no idea how I’m going to do it! I saw someone else do it on here. Somebody make a pcb for this!!!
Anyways, tips and tricks welcome
Swanberrypi 2
- goosewerks
- Posts: 93
- Joined: Mon May 22, 2017 8:27 am
- Has thanked: 18 times
- Been thanked: 39 times
Re: Swanberrypi 2
You CAN tap the original controls, especially if you're good at trace scratching, but I used copper tape in my project. The battery was another issue. Good luck, it's a fun build!
Re: Swanberrypi 2
I have no idea how to trace scratch♂️ It’s gunna be tough no doubt about that. I think the biggest issue is that I️ really want to be able to switch back and forth with portrait modegoosewerks wrote: ↑Fri Nov 17, 2017 8:53 pmYou CAN tap the original controls, especially if you're good at trace scratching, but I used copper tape in my project. The battery was another issue. Good luck, it's a fun build!
- goosewerks
- Posts: 93
- Joined: Mon May 22, 2017 8:27 am
- Has thanked: 18 times
- Been thanked: 39 times
Re: Swanberrypi 2
I tried and failed a few times. Couldn't get any solder to hold, so I did the copper tape. Much easier, worked perfectly. To do the portrait / landscape modes, you'll need some creative programming and button mapping. I didn't wire both Dpads either, just the bottom dpad.yousl3ss wrote: ↑Mon Nov 20, 2017 10:24 amI have no idea how to trace scratch♂️ It’s gunna be tough no doubt about that. I think the biggest issue is that I️ really want to be able to switch back and forth with portrait modegoosewerks wrote: ↑Fri Nov 17, 2017 8:53 pmYou CAN tap the original controls, especially if you're good at trace scratching, but I used copper tape in my project. The battery was another issue. Good luck, it's a fun build!
Who is online
Users browsing this forum: No registered users and 1 guest