Retropie Handheld Project
Retropie Handheld Project
I'm pretty new to making handhelds, and so far with my first handheld it is going great. I was wondering if anyone could tell me how to hook up my audio jack to my pi zero w. Any help would be greatly appreciated, this is the audio jack I am usinghttps://www.adafruit.com/product/1699.
- Robbi_Blechdose
- Posts: 3
- Joined: Sun Feb 11, 2018 10:34 am
- Been thanked: 5 times
Re: Retropie Handheld Project
You might be able to use PWM audio.
These audio jacks usually work something like this: https://cdn.head-fi.org/a/19786.jpg
Basically, pipe your signal in one wire (one each for L and R) and GND in one, and then it outputs it to the jack if plugged in, if nothing's plugged in, it'll output the signal to the other leads instead.
These audio jacks usually work something like this: https://cdn.head-fi.org/a/19786.jpg
Basically, pipe your signal in one wire (one each for L and R) and GND in one, and then it outputs it to the jack if plugged in, if nothing's plugged in, it'll output the signal to the other leads instead.
-
- Posts: 6
- Joined: Thu May 24, 2018 3:37 am
Re: Retropie Handheld Project
A USB DAC that uses a PCM2704
https://rover.ebay.com/rover/0/0/0?mpre ... 1786666187
Then you can wire it straight into the usb. Sound quality will be a lot better
https://rover.ebay.com/rover/0/0/0?mpre ... 1786666187
Then you can wire it straight into the usb. Sound quality will be a lot better
Who is online
Users browsing this forum: No registered users and 1 guest