This is the pre-final prototype.
It comes on a single PCB with the shell attached, simply snap off the shell (like a real peanut) and solder everything down.
You don’t need any glue or screws or 3D printing to make Peanut.
0.96" OLED screen
Injection moulded joystick for a proper arcade feel
Rubber button caps for comfort
Small but sturdy power switch
Tiny - 50x35mm
It uses a 360mAh battery, which lasts up to 12 hours and fully charges in 1 hour.
I’m planning to have kits available for $20 on tindie, which includes everything except the battery.