Page 1 of 1
[Guide] Simple guide for cutting screen area
Posted: Mon Jul 04, 2016 2:17 pm
by skrapps914
I found this to be the easiest method to getting the proper surround cut out
Just use the standard screen cover as a guide
Re: [Guide] Simple guide for cutting screen area
Posted: Tue Jul 05, 2016 12:28 am
by BadBert
Thanks for the tip!
will be using this to be able to mount my screen protector (with print) from dominator
Re: [Guide] Simple guide for cutting screen area
Posted: Sun Jul 10, 2016 9:04 pm
by statikeffeck
Good idea. Wish I had seen this before cutting my screen hole, I went flush with the edge
Not sure I can use the screen protector now.
Re: [Guide] Simple guide for cutting screen area
Posted: Mon Jul 11, 2016 12:48 am
by BadBert
statikeffeck wrote:Good idea. Wish I had seen this before cutting my screen hole, I went flush with the edge
Not sure I can use the screen protector now.
Sure u can
just glue som small strips of plastic on the inside on the edge of your screen "hole", so make some little lips
Re: [Guide] Simple guide for cutting screen area
Posted: Fri Aug 05, 2016 6:54 pm
by RxBrad
My Dremel attachment kit has these tiny little washers that you attach on either side of a cutting disc. I take one of those washers and put it in the indent where the original screenshield was. I roll the washer around the edge of the indent with a fine tipped marker inside the opening of the washer.