I'm creating an AIO-style PCB (I want to learn, so I'm creating my board). I'm using a raspberry PI zero.
To create the audio, I chose the PAM8403 IC because it is a stereo. First I made the pwm filter for raspberry using pins 0 and 1. Soon after the signal was sent to PAM8403. Is the schematic correct?
Another question is about the headphone, I have read a lot about it, but I did not understand and I could not find a solution to put a p2 jack for headphone because the ground is not common for L and R.
Sorry, I'm graduated in software development, I'm self-dictated in electronics.
My schematic:
PWM Audio Filter + Amp Stereo
-
- Posts: 48
- Joined: Fri Sep 30, 2016 12:17 am
- Has thanked: 11 times
- Been thanked: 6 times
Re: PWM Audio Filter + Amp Stereo
Hi I am still learning myself but from what I have learned the headphone jack will go before the amp
Please see this thread for more info and go to the fourth from last image
http://www.sudomod.com/forum/viewtopic.php?f=13&t=1607
Please see this thread for more info and go to the fourth from last image
http://www.sudomod.com/forum/viewtopic.php?f=13&t=1607
Re: PWM Audio Filter + Amp Stereo
Thanks for the reply, but in that case it is using USB audio. Is different from my project.Cyborg_delta1 wrote:Hi I am still learning myself but from what I have learned the headphone jack will go before the amp
Please see this thread for more info and go to the fourth from last image
http://www.sudomod.com/forum/viewtopic.php?f=13&t=1607
The question is how to use the PAM8403 which is class D with headphone:
Note: The left and right channel output of the "negative" can not be connected together, otherwise it will burn IC, and should be preceded powered speakers connected (load).
Who is online
Users browsing this forum: No registered users and 1 guest