Back of raspberry pi 0

[Jman11]

I was wondering if anyone knew where I could find information as to what all the solder points on the back of the Pi do?

Especially the pp# stuff

[crispy_tofu]

This may help, although it doesn't account for all of the pads:
http://hackers.gallery/841/misc/raspber ... ad-probing

[Jman11]

https://docs.google.com/spreadsheets/d/ ... edit#gid=0

I found this if anyone else looks on here. It could help

[Popcorn]

The spreadsheet is wrong on PP22 and 23. Those are data +/- for USB. I'm using them so I know.

[Popcorn]

Oh yeah, PP1 and PP6 is 5V VIN and GND. You can feed your USB that you are mapping on PP22 and PP23 from here too.

[Robvp]

Be careful with pp22 and 23, those are tiny and very close to each other, I made the mistake of putting too much solder on the wire end and ended up bridging the 2, took me a while to remove the excess and now I'm too afraid to use them for anything

Contemplating using the port instead but that will take some much needed room