sudomod

i hacked away a hold gameboy SPand was wondering if the buttons will work on the pi zero GPIO without me doing anything to the line itself?
when the button is pressed high i get 16 resistance or 19 and when its unpressed low i get 9.
im a noob with electronics

ShipStreeT wrote:i hacked away a hold gameboy SPand was wondering if the buttons will work on the pi zero GPIO without me doing anything to the line itself?
when the button is pressed high i get 16 resistance or 19 and when its unpressed low i get 9.
im a noob with electronics

If I understood you correctly, you want to use GPIO instead of a dedicated USB controller, right?
If that is the case, then no, it will not work out of the box. You can make it work over GPIO, though. Here is a nice guide for that:
http://www.sudomod.com/forum/viewtopic.php?f=22&t=57

the GPIO isnt the problem i already managed to wire and make that work ;p,
the problem is ripped 2 contact pads for the up and left buttons and was wondering if any one know where i can find that trace on the board to wire from there or if any one know where i can order just a pcb with buttons on it for the gameboy SP version