Page 1 of 1
Back of raspberry pi 0
Posted: Fri May 20, 2016 12:38 am
by Jman11
I was wondering if anyone knew where I could find information as to what all the solder points on the back of the Pi do?
Especially the pp# stuff
Re: Back of raspberry pi 0
Posted: Fri May 20, 2016 3:33 am
by crispy_tofu
This may help, although it doesn't account for all of the pads:
http://hackers.gallery/841/misc/raspber ... ad-probing
Re: Back of raspberry pi 0
Posted: Sun May 29, 2016 11:26 pm
by Jman11
https://docs.google.com/spreadsheets/d/ ... edit#gid=0
I found this if anyone else looks on here. It could help
Re: Back of raspberry pi 0
Posted: Fri Jun 03, 2016 4:18 am
by Popcorn
The spreadsheet is wrong on PP22 and 23. Those are data +/- for USB. I'm using them so I know.
Re: Back of raspberry pi 0
Posted: Fri Jun 03, 2016 5:53 am
by Popcorn
Oh yeah, PP1 and PP6 is 5V VIN and GND. You can feed your USB that you are mapping on PP22 and PP23 from here too.
Re: Back of raspberry pi 0
Posted: Mon Jun 06, 2016 9:47 am
by Robvp
Be careful with pp22 and 23, those are tiny and very close to each other, I made the mistake of putting too much solder on the wire end and ended up bridging the 2, took me a while to remove the excess and now I'm too afraid to use them for anything
Contemplating using the port instead but that will take some much needed room