Composite vs DPI

Discussion about other hardware (including other Pi-like boards)
Im2nelson4u
Posts: 13
Joined: Thu Oct 19, 2017 10:12 pm
Been thanked: 1 time

Re: Composite vs DPI

Post by Im2nelson4u » Fri Nov 03, 2017 5:49 am

Lol i build alot of gundam models so putty work and sanding is not too bad. I wish i was able to design pcbs like you guys. I just used a forstner bit to drill out a large hole where the buttons are on the sp shell and 3D printed something to add X Y buttons using 3ds buttons.

I was reading through your SP aio board and was wondering if you knew the model number of the 3.2in lcd? All i know is its 40 pin and 16bit color, perhaps u could get it to run in dpi mode lol. Also how far are you alomg with the aio board?

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests