Does anyone know the dimensions of a SNES controller?

Discussion about other hardware (including other Pi-like boards)
Post Reply
User avatar
jb32647
Posts: 86
Joined: Wed Dec 07, 2016 5:33 pm
Has thanked: 2 times
Been thanked: 11 times

Does anyone know the dimensions of a SNES controller?

Post by jb32647 » Wed Dec 07, 2016 6:08 pm

Hello, I am planning on making a portable using the board and pads from a SNES controller. I cannot however seem to find accurate dimensions of the controller online. I want to avoid chopping up the PCB as much as possible, so a dimension sheet like this would be very helpful. If someone could please measure their controller and post the dimensions in mm, that would be very helpful thanks.
An amateur at best. Current project: GB 'Athena'

Daniel_N
Posts: 39
Joined: Fri Aug 05, 2016 12:56 am
Has thanked: 3 times
Been thanked: 3 times

Re: Does anyone know the dimensions of a SNES controller?

Post by Daniel_N » Wed Dec 14, 2016 2:46 am

10 sec. google ->
http://s15.photobucket.com/user/o1s1n/m ... s.jpg.html
I have one of this @home, the measurements are the same as original

Surgical_Precision
Posts: 8
Joined: Thu Feb 15, 2018 3:32 am
Has thanked: 2 times

Re: Does anyone know the dimensions of a SNES controller?

Post by Surgical_Precision » Tue Jan 01, 2019 9:20 am

I took out a (off-brand) controller and a pair of callipers to confirm, it's noteworthy to add that the measurements make a lot more sense in inches. The D-pad, for example, is exactly 1 inch wide and 11/16 from the left edge.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest