Page 1 of 1
BW 3.5 Inch TFT LCD Monitor
Posted: Fri Jun 10, 2016 8:16 pm
by zeesh
Hi There! Just got my monitor.
https://www.amazon.com/BW-3-5-Inch-Moni ... entries*=0
Can anyone tell me how to properly remove the screen from its enclosure? It seems to be very securely fastened and I don't want to try to force it out, as I fear that I might break the actual screen.
Re: BW 3.5 Inch TFT LCD Monitor
Posted: Fri Jun 10, 2016 9:49 pm
by natethegreat28
use a hair dryer to loosen the glue that hold the screen in. Then lift up the screen bezel with a thin flat tool. Bezel and the screen will come out with no damage, and you will be able to reuse the bezel if need be.I hope this helps you and good luck with your project
Re: BW 3.5 Inch TFT LCD Monitor
Posted: Wed Jun 15, 2016 12:29 pm
by Alvaro
I ordered the same screen.
The description says 12v, but my question is, runs directly with 5v or a modification is needed?
Sorry about my english.
Greetings from Uruguay!
Re: BW 3.5 Inch TFT LCD Monitor
Posted: Wed Jun 15, 2016 1:30 pm
by Robvp
Depends on the PCB, some do and some don't, I ordered that same one from seller Niceshopping and required a small modification ton run on 5v
Re: BW 3.5 Inch TFT LCD Monitor
Posted: Wed Nov 22, 2017 4:54 am
by Stanya
Robvp what mod did you have to do?
Re: BW 3.5 Inch TFT LCD Monitor
Posted: Wed Jun 13, 2018 2:35 pm
by spacemishka
Re: BW 3.5 Inch TFT LCD Monitor
Posted: Wed Jun 13, 2018 3:01 pm
by spacemishka
Is it possible to power this variant with 3V3?
