[Question] About Wires

Discussion about other hardware (including other Pi-like boards)
User avatar
Posts: 574
Joined: Wed May 11, 2016 4:40 pm
Location: Washington, USA
Has thanked: 35 times
Been thanked: 84 times

Re: [Question] About Wires

Post by Kilren » Thu Jun 30, 2016 10:53 am

Alvaro wrote:I'm trying to economize, so i'm going to recycle some wires.

For the data cables, i think use those wires from pc front panel buttons and leds.
And for 5v and gnd, wires from pc power supply.

Any suggestion? is this a bad idea?

No problem there! Don't over complicate it. Almost anything you can get your hands on is fine. My only larger than the rest wire in my build is from the PC1000C to the power board. Everything else is ethernet cable (around 26-28AWG)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest