Page 1 of 1

PowerBoost 1000C Issue: Very Early Low Batt Warning

Posted: Wed Jun 29, 2016 1:19 am
by chiz
During my burn-in test of my GB Pi 2, I noticed a strange behavior with the PowerBoost 1000C -- the red low battery LED warning flashing after a few minutes of use.

I started with a fully charged battery with the multimeter reporting 4.18v and recorded the following:
  • @4.18v - red LED is off
  • @3.84v - red LED rapidly flashing intermittently
  • @3.72v - red LED constantly lit
Spec sheet for the PB 1000C says low batt warning is triggered at 3.2v level but I'm seeing differently. This appears to be a known issue with the PB 1000C and being discussed over at Adafruit's forums.

Links to the discussion below:
  1. PowerBoost 1000C Low Battery Warning Triggers Too Soon
  2. PowerBoost 1000C Low Bat Led

Anyone else encounteres the same?

Re: PowerBoost 1000C Issue: Very Early Low Batt Warning

Posted: Wed Jun 29, 2016 1:53 am
by Fleder
Yes, i've got the same problem with mine, but haven't had the time yet to address this issue.