sudomod

Here is a small power bank for my Minty Pi. It isn't 3D printed (It's white because I ran out of colored filament). It has the same 1200 mah as the mintypi and outputs 5v at 500 milliamps (only 500 milliamps because the adafruit mocrolipo only supports charging at 500 milliamps).

That's awesome! what if you put it an an Altoids smalls?

needs a neodymium magnet inside to hold it to the minty tin!

abrugsch wrote: ↑

Fri Nov 17, 2017 7:48 am

needs a neodymium magnet inside to hold it to the minty tin!

Would the magnet interfere with the pi? Or sound maybe, because this sounds interesting but i dont want to mess anything up. Velcro sounds the safer option