Help with Mintypi V2 bridged solder points

General mintyPi-related chat goes here. Share ideas, ask questions that don't fit into the hardware/software help forums, etc.
Post Reply
justin22
Posts: 1
Joined: Fri Apr 30, 2021 2:41 am

Help with Mintypi V2 bridged solder points

Post by justin22 » Fri Jun 04, 2021 9:09 pm

So, I'm currently putting together my Mintypi V2 kit, and I accidently bridged the pins for the b button and ground while soldering the Pi gpio pin holes to the button pcb. I've been attempting to break this bridge with Lester 186 no clean flux and some wire for a while now, but I'm not having any luck. Is there anything I'm overlooking?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest