Tin cutouts

General mintyPi-related chat goes here. Share ideas, ask questions that don't fit into the hardware/software help forums, etc.
Post Reply
Hunthill98
Posts: 1
Joined: Sun Jun 13, 2021 3:16 pm

Tin cutouts

Post by Hunthill98 » Sun Jun 13, 2021 3:21 pm

Hi I was wondering if there were good ways to cutout the tins. I tried using my drill on my first one but I bent the tin a lot. Any advice that could help?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest