2.2tft screen
- rodocop
- Posts: 1723
- Joined: Mon Aug 22, 2016 3:14 pm
- Location: Saskatchewan
- Has thanked: 606 times
- Been thanked: 608 times
Re: 2.2tft screen
yeah, you can use a 2.2" wermy still has 3d files to download for the 2.2" version. As for wiring it will be a little different, if you get a screen that has an attached red board you'll need to trim it a bit and remove the SD card holder, and the header pins and solder wires to the button PCB. If you buy a bare screen with only the ribbon you'll need to use one of moosepr's ili plates (get one from OSH park for cheap), and solder the screen to that, and then wire it to the PCB.
You'll also have a hard time finding a button PCB, but if you have already you'll be good to go. In the end a 2.4" is a better choice, so unless you already have a 2.2" i'd get a 2.4"
You'll also have a hard time finding a button PCB, but if you have already you'll be good to go. In the end a 2.4" is a better choice, so unless you already have a 2.2" i'd get a 2.4"
_____________________________________________________
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
Who is online
Users browsing this forum: No registered users and 1 guest