General mintyPi-related chat goes here. Share ideas, ask questions that don't fit into the hardware/software help forums, etc.
- Posts: 5
- Joined: Sun Dec 23, 2018 8:23 pm
- Location: Eightyfour PA
- Has thanked: 4 times
- Been thanked: 3 times
- Posts: 32
- Joined: Sun Apr 23, 2017 8:21 pm
- Has thanked: 75 times
- Been thanked: 20 times
Thanks for the tip regarding the CS-HUY300XL, it fits a treatMintyJam wrote: ↑Tue Dec 25, 2018 5:52 pmI think in that case I'm going for the Huawei CS-HUY300XL. These dimensions are 58,3mm × 51,0mm × 5,2mm, so I guess that there are no spacers needed for this battery, or the cutout is actually bigger than 58mm... Anyways really thanks for replying me so fast!
I ended up getting a 1950mah battery from a Huawei Y300 on Ebay. The model number was HB5V1HV. I basically just found the phone that the CS-HUY300XL battery went to and found an official battery for the same phone. It seems to fit in my case at least. I did tape it down with some low-end double sided tape, just because it popped out once while I was putting the top board in.
Who is online
Users browsing this forum: No registered users and 1 guest