Hinge MOD

General mintyPi-related chat goes here. Share ideas, ask questions that don't fit into the hardware/software help forums, etc.
Post Reply
Tophool
Posts: 3
Joined: Thu Jan 31, 2019 11:00 am
Been thanked: 1 time

Hinge MOD

Post by Tophool » Wed Jun 05, 2019 6:12 pm

I got sick of the hinge constantly coming off the hinge support, so I modded it a bit to be held in place by one of the small screws provided in the kit and a 3D printed cap. I had to file a small amount off the screen bezel to accomodate the sliver of screwhead protruding from it, but that was easier than redesigning and reprinting the screen faceplate ;)

Posted below is the tinkercad link:

https://www.tinkercad.com/things/374G5Qlgbd8

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest