I have solder my raspberrypi to my PCB. All of my points connections are good except my right bumper button. No matter how many times i try to solder that connection I never get a reading from my multimeter.
Another issue I'm having is when I plug in my LCD and power up my pi via USB. The Retropi image loads up and I can click a to configure. The issue is my dpad is not working at all. My connections for these buttons are fine, but when I try to use the actual buttons, nothing happens. Some advice would be awesome!
Help! conductivity issues
- Helder
- Trailblazer
- Posts: 2448
- Joined: Thu May 05, 2016 8:33 am
- Location: Fall River, MA
- Has thanked: 1279 times
- Been thanked: 2963 times
Re: Help! conductivity issues
Show pictures, and you have continuity for the dpad directions from GPIO to the test pads? If you have issues making continuity you can stick a resistor leg or pin from a pin header into the gpio till it hits bottom while the solder is molten then let the solder cool and cut the wire/pin flush.
My Sale Threads:
Retro PSU, 3.5A output!
Chat with me and other members
Don't contact me about obtaining my board files (as you will not get them). Don't contact me about any of my boards if they are sold out, they will be restocked as soon as I can get them.
Don't support thieves like ckliang who copied my AIO to resell and is now cloning the mintyPi, support the original creators and not the thieves!
Retro PSU, 3.5A output!
Chat with me and other members
Don't contact me about obtaining my board files (as you will not get them). Don't contact me about any of my boards if they are sold out, they will be restocked as soon as I can get them.
Don't support thieves like ckliang who copied my AIO to resell and is now cloning the mintyPi, support the original creators and not the thieves!
Who is online
Users browsing this forum: No registered users and 2 guests