Hello Folks,
i semi-successfully assambled my xmas present the MinyPI 3.5. Soldering went fine and card was flashed too.
However i do have the following issue:
1) first boot no SD-Card -> white screen then turns off after 3 secs (i think its normal?)
2) flashed SD Card -> booting now battery no issues, (however i hadnt soldered the L/R buttons not speaker then)
3) Soldered speaker and buttons and did the final assambly
4) POwer on -> white screen -> 2 secs (sometimes one sec) it powers off
5) Fully charged battey until LED was green -> same status
6) Booting on USB-C no success, still powers off immidiatly or after 2 sec latest
7) disattached battery board (dont know just for safy if it can remain attached?) boot on micro USB dirctly -> Boots up with boot screen
What could be the issue for this, i measured all pins and dont see an obvious issue connection per all pins seems fine
MintyPI Boots and works on micro USB, but on USB-C and Battery Turns off
-
- Posts: 1
- Joined: Wed Dec 30, 2020 4:51 pm
- Helder
- Trailblazer
- Posts: 2985
- Joined: Thu May 05, 2016 8:33 am
- Location: Rogers, AR
- Has thanked: 1459 times
- Been thanked: 3114 times
Re: MintyPI Boots and works on micro USB, but on USB-C and Battery Turns off
Test the TX pin when powered through microUSB , measure the voltage there and if it is 0 then you either shorted the pin or Electro Static Discharge could have damaged the GPIO.
This GPIO is crucial in keeping the pi on and also turning it off and if it is damaged then you will need another Raspberry Pi zero to swap with that one, there is no way to fix that once it's damaged.
This GPIO is crucial in keeping the pi on and also turning it off and if it is damaged then you will need another Raspberry Pi zero to swap with that one, there is no way to fix that once it's damaged.
Chat with me and other members On Discord
Don't contact me about obtaining my board files (as you will not get them). If my Boards or PCB Kits are sold out, they will be restocked as soon as I can get them and there is demand for them. You can join the mailing list on my Website to be notified when they are available.
Helder's Game Tech Website
We will not support any cloned work so don't come to us with technical issues to resolve, go talk to the cloner for help.
Don't contact me about obtaining my board files (as you will not get them). If my Boards or PCB Kits are sold out, they will be restocked as soon as I can get them and there is demand for them. You can join the mailing list on my Website to be notified when they are available.
Helder's Game Tech Website
We will not support any cloned work so don't come to us with technical issues to resolve, go talk to the cloner for help.
Who is online
Users browsing this forum: No registered users and 1 guest