Page 1 of 1
Help with my MintyPi Helders v2.0 Board.
Posted: Mon May 21, 2018 11:22 am
by CapnBio
Hey Sudoers!
A bit ago when I got my board late last year, I broke 2 solder spots, they are number 1 and I think number 8 if I counted correctly. Is there an alternate soldering point on it so I would have to complete my project finally.
Re: Help with my MintyPi Helders v2.0 Board.
Posted: Mon May 21, 2018 12:13 pm
by Herb
Put a picture, it will be better
Re: Help with my MintyPi Helders v2.0 Board.
Posted: Mon May 21, 2018 1:01 pm
by CapnBio
Herb wrote: ↑Mon May 21, 2018 12:13 pm
Put a picture, it will be better
https://photos.app.goo.gl/NP8S8JHBLVwhldGh2
More have come off now
Re: Help with my MintyPi Helders v2.0 Board.
Posted: Mon May 21, 2018 5:50 pm
by Helder
It's not that hard to figure out since the silk screen is there along with the test pads. The 2 missing pads I put red X on is not used so ignore those. The 5V which I highlighted purple are connected to VCC and are also connected to the 5V pad so just solder to the one that is left of the missing pad and done.
Green is the LEFT GPIO so solder a wire from the GPIO to the LEFT test pad in green, easy. The number 1 is the SDA for the battery monitor which is highlighted in orange, solder a wire from the Pi GPIO to the SDA test pad and done.