Drill guide
Drill guide
My 3D printed drill guide does not fit completely on the Altoids tin. Are there any adjustments that can be made to get this to fit right?
-
- Posts: 226
- Joined: Tue Jan 31, 2017 11:06 am
- Location: Tianjin / China
- Has thanked: 25 times
- Been thanked: 53 times
Re: Drill guide
In Cura: re-size all tree axis by lets say 1.1 if your result should get bigger.
If you own a calipper: measure the actual size of your print. Than measure the need size of your tin. For each axis!
Example: printed part: 100mm wide.
Mintypi Tin: 90mm wide.
Resulting: 90/100= 0.9
You must shrink your model in Cura by factor 0.9
If you own a calipper: measure the actual size of your print. Than measure the need size of your tin. For each axis!
Example: printed part: 100mm wide.
Mintypi Tin: 90mm wide.
Resulting: 90/100= 0.9
You must shrink your model in Cura by factor 0.9
Who is online
Users browsing this forum: No registered users and 1 guest