Attaching the board to the button PCB

Having trouble with your mintyPi build? Post your questions here!
Post Reply
hendog30_
Posts: 7
Joined: Tue Jul 23, 2019 10:29 pm

Attaching the board to the button PCB

Post by hendog30_ » Thu Jul 25, 2019 12:02 am

Just a few quick questions about attaching the board to the button PCB.

For one, the multi-meter we're using lacks the setting that was used in the build guide. Should the setting matter, or what would you recommend?

Also, is it a good idea to test the continuity between pins as you go, or Sauder the entire board and test continuity afterward?

We've just been having a bit of trouble with this step. Any help would be appreciated.
Thanks! :)

User avatar
gambino37
Posts: 217
Joined: Fri Oct 20, 2017 7:17 am
Has thanked: 4 times
Been thanked: 63 times

Re: Attaching the board to the button PCB

Post by gambino37 » Thu Jul 25, 2019 1:03 pm

The setting has to be for continuity. I would imagine that all multimeters have this setting. Maybe you can upload a picture of the one you are using? When you test for the continuity it really doesn't matter when you check the pins, just as long as you do it at some point.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest