sudomod

Just a few quick questions about attaching the board to the button PCB.

For one, the multi-meter we're using lacks the setting that was used in the build guide. Should the setting matter, or what would you recommend?

Also, is it a good idea to test the continuity between pins as you go, or Sauder the entire board and test continuity afterward?

We've just been having a bit of trouble with this step. Any help would be appreciated.
Thanks!

The setting has to be for continuity. I would imagine that all multimeters have this setting. Maybe you can upload a picture of the one you are using? When you test for the continuity it really doesn't matter when you check the pins, just as long as you do it at some point.