SOLVED!!!
(The version of mintypi software did not fit the screen type.)
Hello,
So today I made the mintypi lite. I soldered the board and tested all the pins and got conductivity. I then continued following along with the new mintypi video. As I got to the boot up the screen just flickers and it will flicker other things if I press buttons but I can't make them out. I went over all my solders and don't see any bridged but still nothing. I was wondering if I could get some help from someone who is way better with this stuff. Attached is some pictures of my soldering spots and a shot clip of boot up.
Thanks.
Mintypi Lite Flickering Screen
-
- Posts: 1
- Joined: Mon May 11, 2020 5:20 pm
Mintypi Lite Flickering Screen
Last edited by Sirprintsalot8 on Tue May 12, 2020 8:27 am, edited 1 time in total.
- LilTrublMakr
- Posts: 365
- Joined: Sun Aug 05, 2018 6:39 am
- Has thanked: 24 times
- Been thanked: 120 times
- Contact:
Re: Mintypi Lite Flickering Screen
Try redoing your solder connections from the pi to the controller PCB. The board will flex a little when being put together and you might have a weak solder connection that gets a little weaker when the board is flexed.
@LilTrublMakr
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
My website
My shop
My MintyPi Services
wpa_supplicant generator
Sudomod Wiki Links:
-mintyPi FaQ
-mintyPi V3: parts, tools needed, build guide, and software
-mintyPi V3: How to connect to WiFi and transfer ROMs. A step by step picture guide!
My projects:
Circuit Sword CM3 Build
Who is online
Users browsing this forum: No registered users and 1 guest