Page 7 of 44
Re: [interest check] DMG pre-cut cases
Posted: Thu Jul 06, 2017 7:55 am
by kubino
SuperAIO LEDs in action :
https://youtu.be/aZr3-uMiO0I
PS: Ignore the light tube's I have ordered other ones. They are just for tests.
Re: [interest check] DMG pre-cut cases
Posted: Mon Jul 10, 2017 4:21 pm
by dryja123
kubino wrote: ↑Thu Jul 06, 2017 7:51 am
ok 1st post updated with list of members who contacted me. Please check if I write the info correctly. Hope I havent forgot anybody
I'm there! Please send me a PM when you're ready to go.
Re: [interest check] DMG pre-cut cases
Posted: Mon Jul 10, 2017 10:12 pm
by exoboy
Would like a grey one with kite SuperAIO USB and X/Y holes. Unsure about LED holes - in the example pic they're much larger than I would like.
Re: [interest check] DMG pre-cut cases
Posted: Mon Jul 10, 2017 11:26 pm
by ABH
Great job .. so clean
Re: [interest check] DMG pre-cut cases
Posted: Tue Jul 11, 2017 3:52 am
by jsawhite
if you're still taking reservations, I'd be interested in a black one. Using Kite's SAIO (second gen), so usb and led holes would be great!
Re: [interest check] DMG pre-cut cases
Posted: Tue Jul 11, 2017 4:40 am
by kubino
exoboy wrote: ↑Mon Jul 10, 2017 10:12 pm
Would like a grey one with kite SuperAIO USB and X/Y holes. Unsure about LED holes - in the example pic they're much larger than I would like.
ok, will put you in a list. The holes in picture are 3mm, but I can do 1.2mm radius or even smaller.
Re: [interest check] DMG pre-cut cases
Posted: Tue Jul 11, 2017 8:03 am
by Johnny sublime
Could you make the recess around the x y buttons like on the a b buttons
Re: [interest check] DMG pre-cut cases
Posted: Tue Jul 11, 2017 8:41 am
by kubino
Johnny sublime wrote: ↑Tue Jul 11, 2017 8:03 am
Could you make the recess around the x y buttons like on the a b buttons
maybe, but I'd rather not doing it because as the plastic between X/Y is quite thin.
Re: [interest check] DMG pre-cut cases
Posted: Tue Jul 11, 2017 9:12 am
by dryja123
I'm going to be using HoolyHoo's SAIO screen bracket with button wells, printed by HoolyHoo. Do you know if the button hole alignment will match exactly to HoolyHoo's bracket? If the measurements are off slightly I'll have to cut the bracket.
Re: [interest check] DMG pre-cut cases
Posted: Tue Jul 11, 2017 9:55 am
by kubino
dryja123 wrote: ↑Tue Jul 11, 2017 9:12 am
I'm going to be using HoolyHoo's SAIO screen bracket with button wells, printed by HoolyHoo. Do you know if the button hole alignment will match exactly to HoolyHoo's bracket? If the measurements are off slightly I'll have to cut the bracket.
I think it looks pretty close
- SAIO_Hoolyhoo.png (84.26 KiB) Viewed 7474 times