sudomod

Have a bunch of parts left over from some various Gameboy Zero and Freeplay Zero builds.

I'd like to sell everything has a package deal (or at least the DMG-01 stuff and then a separate package for the GBA stuff).

GBZ/DMG-01:
Screen bracket - Hoolyhoo's SNES plus one with spots for USB, volume wheel and Pi. I had 2 printed this one isn't quite perfect around the inside edge that sits on top of the screen but it shouldn't pose any issues.
Couple of speakers
Some pigtail wiring with 2 pin mini JST connectors (have both female and male)
Original style DC jacks
Black button caps, I have used these on both my builds on the rear buttons maybe like 50 of them left.
D-Pad silicone
5 pin headphone jacks
One BW screen controller board 5V modded
Ton of tactile buttons (I think like maybe 90)
Few power slide switches - these have the side solder pins rather than underneath
MicroUSB socket on breakout board
Selection of screws
Complete set of original color buttons (D-pad, power switch and A/B, also have the Ext cover)
Plastic screen protector
Some Phillips and Tri-Wing screwdrivers
$30 + shipping continuous 48 US startes


FPZ-GBA:
Raspberry Pi Zero (non W) (not pictured, forgot I had it, but it is brand new and never used)
Silver case
Buttons galore (I think I have 3 complete sets of gray, I also have a complete yellow set just missing the B button and red set just missing the A button)
Buttons caps (selection of colors, these fit the FPZ XY buttons)
Complete rubber pad set + extra D-pad rubber
2 plastic screen protectors
Selection of screws
Some screwdrivers too
$20 + shipping continuous 48 US startes

If you want a selection of things from both packages then I'm open to offers, just trying to avoid doing deals like 2 button caps and a switch and then have to deal with shipping it all.

I also have a brand new genuine Adafruit Powerboost 1000C. $15 with either package.

This post can be ignored. VeteranGamer showed me the link to Hoolyhoos bracket. Sorry for disturbing the sales thread.
http://sudomod.com/forum/viewtopic.php? ... =10#p50965
==============

Did you modify the STL of the bracket yourself? I was planning to do more or less the same modifications as you, but haven't spent too much time on figuring out how to do this ( I got me Fusion 360 for this). In my current build I just glued additional cubes on the bracket.
Or did I just miss these files on the forums?
If you have the files, would you be willing to share those?
Maybe Hoolyhoo should say if he is ok with that first.
I just think that anyone with a similar build (no AIO) will need a similar bracket with those supports for volume wheel and he Pi..